Pump on an extension lead
We fit a weatherproof power point for the pump, protected by a safety switch (RCD).

Power that is safe around water.
A pool electrician in Newcastle, Lake Macquarie, Maitland and Port Stephens for pumps, spas, heaters and outdoor power.
5.0 from 205 Google reviews
Water and electricity need a careful hand. Here is what we see most.
We fit a weatherproof power point for the pump, protected by a safety switch (RCD).
Water in a fitting, old cable or a failing pump. We test until we find the cause.
Fault finding >
We check your switchboard can carry the load, then run a dedicated circuit for the heat pump.
Spas connected, isolated and reconnected, timed around your tilers and builder.
Tell us what is going on. We ring you back, usually the same day.
At a Mayfield home we laid conduit in the trench and put a weatherproof power point on a post for the pool and shed.
Electrician Mayfield >
In New Lambton we ran pool power from a granny flat on a catenary wire, with an isolator ready for a future heater.
Electrician New Lambton >
In Merewether we disconnected a spa for the tilers, laid new conduit in the slab, then reconnected it.
Electrician Merewether >
At a Thornton home we fitted weatherproof power points and wall fans around an indoor pool deck.
Electrician Thornton >
Send photos of the pool area and your switchboard.
Cable route, safety switch and power points planned before we start.
A CCEW (Certificate of Compliance for Electrical Work) and a lifetime workmanship warranty.
Lights and fans for the outdoor area too.
Read more >Outdoor and weatherproof power where you need it.
Read more >Garden, deck and sensor lights.
Read more >Protection that stops a shock.
Read more >Room for a pump and heater on a safe board.
Read more >For the power, yes. We install the power point and circuit for the pump, and your pool builder or plumber fits the pump.
No, because a lead near water is a shock risk. A weatherproof power point on its own safety switch is the safe fix.
Yes, once we check your switchboard and supply can carry the extra load. If the supply needs upgrading, we arrange the network connection work.
Yes. We connect new spas with a safety switch and isolator, and can disconnect and reconnect a spa around tilers and builders.
Tell us what is going on. We will ring you back, usually the same day.
In a hurry? Call 0400 232 172